Useful Product IDs

This crimp tool is proven to work for the Molex KK clones listed below, using the 2.0mm crimp head. Will also be tested on the JST connectors when I have a chance - TBSliver (talk)

• Molex Tool 1

JST connectors are great for small motor connectors, and wiring boards to other boards. They're 2.54mm standard spacing, specced for 3A per terminal. They are commonly found on RC batteries acting as balance connectors.

• 2 Way 2
• 3 Way 3
• 4 Way 4
• 5 Way 5
• 6 Way 6
• 8 Way 7

• 2 Way 8
• 3 Way 9
• 4 Way 10
• 5 Way 11
• 6 Way 12
• 8 Way 13
• Crimp Terminals 14

Molex's KK series connectors are used for the same thing as JSTs. Fan connectors for PC mainboards use KK series. There is a Multicomp clone of them availabe on farnell for ~10p less per connector.

• 2 Way 15
• 3 Way 16
• 4 Way 17
• 5 Way 18
• 6 Way 19
• 8 Way 20

• 2 Way 21
• 3 Way 22
• 4 Way 23
• 5 Way 24
• 6 Way 25
• 8 Way 26
• Crimp Terminals 27

These are the connectors used inside computers and all over the place to connect to regular pin headers.

• Single Row, 2 Way 28
• Single Row, 3 Way 29
• Single Row, 4 Way 30
• Single Row, 5 Way 31
• Single Row, 6 Way 32
• Single Row, 8 Way 33
• Single Row, 10 Way 34
• Single Row, 12 Way 35

<!– –>

• Dual Row, 6 Way 36
• Dual Row, 8 Way 37
• Dual Row, 10 Way 38
• Dual Row, 12 Way 39
• Dual Row, 16 Way 40
• Dual Row, 20 Way 41
• Dual Row, 22 Way 42
• Dual Row, 24 Way 43

<!– –>

• Crimp Terminals 44

• 18 Way Pin Headers 45
  • Cheapest of the options at 1.16p per pin!

• 2.45mm Easy release terminal block - 8 way 46

• 2 terminal 2.54mm pitch
• 3 terminal 2.54mm pitch
• 4 terminal 2.54mm pitch
• 8 terminal 2.54mm pitch

• 2 terminal 5.08mm pitch
• 2 terminal 5.08mm pitch
• 3 terminal 5.08mm pitch
• 4 terminal 5.08mm pitch
• 6 terminal 5.08mm pitch
• 8 terminal 5.08mm pitch
• 12 terminal 5.08mm pitch

• Nice Barrel Jack - same size as arduino 47
• PC Hard disk connector - 6.5A, can plug into a PC PSU to supply +5v and +12v 48
• PC ATX Connector - loads of voltages, and control over the PSU 49
• PC ATX 12V Connector - good to get loads more 12V juice onto your board - 8A per connector = 16A total 50

• Black clip-on 4mm banana plug 5x 51
• Red clip-on 4mm banana plug 5x 52
• Green clip-on 4mm banana plug 5x 53
• Orange clip-on 4mm banana plug 5x 54
• Yellow clip-on 4mm banana plug 5x 55
• Grey clip-on 4mm banana plug 5x 56
• Grey wire-to-wire connector 57

• 3A SOT23 (tiny surface mount) MOSFET 58
• 3A SOT223 (bigger surface mount) MOSFET - can be drivben directly from an arduino pin - used in Screamin' Frank to control RGB strips 59

Category:Suppliers