Rating plate information:

• Rated Power - 500w
• Spindle Speeds - 280-2350 rpm
• Drill Chuck - 1.5 - 16mm
• Drill Capacity - 35mm wood
• Spindle Travel - 50mm
• http://doc.ferm.com/Servotool/documents/833524%20Manual-UK%20%200210-22.pdf

We advise users of the drill press to:

• Check the machine is in safe working order before using it

<!– –>

• Tie back long hair, remove loose jewelry, and secure loose clothing before using this equipment

<!– –>

• Safely and securely clamp work before drilling it

<!– –>

• Do not leave the key in the chuck

<!– –>

• use the guard attached to the drill

<!– –>

• Not use gloves when using the drill (there have been incidents where this has caused injuries by pulling hands into the drill)

<!– –>

• Be aware of swarf, and raise the drill bit occasionally to allow the swarf to break away

<!– –>

• clean up and inspect the machine after use

Category:Equipment