Add a New Printer:

• Other
• Custom
• Machine Name: Mendel90
• Machine Width: 200
• Machine Depth: 200
• Machine Height: 200
• Nozzle Size: 0.4
• Heated Bed: Yes
• Bed Center is 0,0,0: Yes

Please note! These settings are from 2015, you may have better luck using the Slic3r settings instead. Download the Mendel90 Cura settings from: 1

• File → Open Profile
• Select the file you downloaded

Download the Mendel90 Slic3r settings from: 2

• File → Load Config Bundle
• Select the file you downloaded

As we print on a glass sheet if we need new glass sheet then the following must be satisfied.

1. Glass sheet must be 200 * 200 size
2. Idealy using Borosilicate Glass that is around 3mm thickness
3. Must be bought in a batch and cut from the same sheet to ensure we have multiple surfaces that are exacvtly the same thickness
4. 3D printer will be out of action until calibrated for the new glass surfaces

1. Place 3D object onto the Cura platform, rotate and scale it however you need. You can place multiple items on the bed if you need to print multiple things. It's a good idea to leave a few millimetres gap around the edge of the platform, just in case.
2. Check the above settings and profile are loaded into Cura.
3. If you're happy with the print time and amount of filament it'll use, export the toolpath to a location on your computer.
4. Browse to either http://mendel90/ or http://m90.hacman.org.uk/ in your browser and log in to Octoprint using the details provided next to the printer itself.
5. Load the .gcode toolpath file.
6. Clear the printing bed of any other items.
7. Click print!

Make sure you watch your print for a good duration at the start so you can stop any problems that happen, such as the filament not sticking to the heated bed.

You can also watch your print using the control tab in Octoprint.

1. Hit the stop button in Octoprint.
2. Under the control tab, hit the home buttons under both the X/Y and Z columns.
3. Recover your print from the bed.

RA

Category:Mendel 90 Category:Team_3D_Print