old:projects:diy-laser-cutter [Hacman DEMO ONLY]

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

This project is to build an A2 sized Laser Cutter, based on BuildLog,
Lasersaur, and axcut lasers.

Project Members
---------------

-   Bob
-   Tas

Project Specifications
----------------------

-   Use a 40W tube, upgradable to an 60W if we have the money (so 1000mm
    x 55mm tube size to accommodate)
-   Bed big enough for A2 Sheets (420mm x 594mm), possibly a bit bigger.
-   Z axis movable up to 200mm
-   Fit closely within the bounds of the existing laser cutter (1000mm x
    600mm)
-   lid at height of bed, to allow huge pieces to be put all the way
    through
-   Air assist
-   LAOS control
-   Extraction from below the bed
-   Complete floor-standing unit, containing all necessary parts to run
    (water reservoir etc)
-   RFID control and job time logging
-   Emergency stop button
-   Possible CO2 Flush button
-   Lockable casters so it can be moved.
-   Quieter pump
-   Actually wire up flow sensor to something