old:equipment:wood-pillar-drill [Hacman DEMO ONLY]

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

This drill runs at the correct speed for drilling through wood and
similar materials. Its speed can be easily adjusted by changing the belt
position in the top compartment.

### Power Craft DP500

Rating plate information:

-   Rated Power - 500w
-   Spindle Speeds - 280-2350 rpm
-   Drill Chuck - 1.5 - 16mm
-   Drill Capacity - 35mm wood
-   Spindle Travel - 50mm
-   <http://doc.ferm.com/Servotool/documents/833524%20Manual-UK%20%200210-22.pdf>

### Safety

We advise users of the drill press to:

-   Check the machine is in safe working order before using it

<!-- -->

-   Tie back long hair, remove loose jewelry, and secure loose clothing
    before using this equipment

<!-- -->

-   Safely and securely clamp work before drilling it

<!-- -->

-   Do not leave the key in the chuck

<!-- -->

-   use the guard attached to the drill

<!-- -->

-   Not use gloves when using the drill (there have been incidents where
    this has caused injuries by pulling hands into the drill)

<!-- -->

-   Be aware of swarf, and raise the drill bit occasionally to allow the
    swarf to break away

<!-- -->

-   clean up and inspect the machine after use

[Category:Equipment](Category:Equipment "wikilink")